. OPERATION TRANSPORTATION TRANSPORTATION When transporting the machine, observe all related laws and regulations, and be careful to assure safety. TRANSPORTATION PROCEDURE As a basic rule, always transport the machine on a trailer. type of bucket. LOADING, UNLOADING WORK WITH TRAILERS WARNING When loading or unloading, always use ramps or a platform. Proceed as follows. LOADING 1. Load and unload on firm level ground only. Maintain a safe distance from the edge of a road. 2. Apply the brakes on the trailer securely and insert locks (1) under the tires to hold the trailer in position.
Set the distance (3) between ramps (2) to match the distance between the left and right tires, and make angle (4) of the ramps a maximum of 15 ° . If ramps (2) sag appreciably under the weight of the machine, put wooden blocks (5) under the ramps to support them. 3. Determine the direction of the ramp, then slowly load the machine. 4. Load the machine correctly in the specified position on the trailer.
3 - 114 When selecting the trailer, see the weights and dimensions Note that the specifications for the weights and dimensions f or transportation differ according to the type of tires and When loading or unloading the machine, run the engine at low s peed, travel at low speed, and operate slowly. level ground. install them securely at an angle of less than 15°. d make sure that the slope face does not collapse. hine from slipping to the side on the ramps. ramps. machine may tip over. When loading or unloading the machine, stop the trailer on firm In addition, keep well away from the road shoulder.
Use ramps of ample width, length, thickness, and strength, and When using an embankment, compact the fill soil thoroughly an Remove the mud stuck to the undercarriage to prevent the mac In addition, remove any water, snow, ice, grease, or oil from the Never change direction on the ramps. There is danger that the If it is necessary to change direction, return to the ground surfac e or the trailer platform, correct the direction, and start again. The position of the center of gravity of the machine will change suddenly at the connection of the ramp and trailer, and there is danger of the machine losing its balance. Always drive slowl y over this point.