Komatsu — HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC

. MAINTENANCE OUTLINES OF SERVICE 4 - 5 COOLANT AND WATER FOR DILU TION n of preventing corrosion as well as preventing freezing. ot an issue, the use of antifreeze coolant is essential. Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has The coolant has the important functio n of preventing corrosion as well as preventi ng freezing Even in the areas where freezing is n ot an issue, the use of antifreeze coolant is e ssentia Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (A F-NAC excellent anticorrosion, antifreeze and cooling propertiesand can be used continuo usly for 2 years o r 4000 h ours.

Komatsu Supercoolant (AF-NAC) is s trongly recommended wherever available. use distilled water or tap water (soft water). mounts of minerals (calcium, When diluting the antifreeze coolant, Natural water, such as a river water or well water (hard water), contains large a miner calcium, magnesium, etc.), and this makes it ea sier for scale to form inside the engine or rad iator. Once scale is deposited inside the engine or radiator, it is ex tremely difficult to remove. It also causes o verheating due to poor heat exchange, so when you dilute the co olant, we recommend that you use water with an overall hardness of less ve the precautions given in the Operation and Maintenance Manual.

e sure to keep it away from flame. o water differs according to the ambient temperature. ee "CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-20)". lied already mixed. In such cases, never dilute with water. ngine to cool before adding coolant. h an overal l hardness o f less than 100 PPM. When using antifreeze, always obser ve the precautions given in the Operation an d Maintenance M anual. Antifreeze coolant is flammable, so b The ratio of Supercoolant (AF-NAC) t o water differs according to the ambient tem perature For details of the ratio when mixing, s ee "CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-20)". Supercoolant (AF-NAC) may be supp lied already mixed.

In such cases, never dil ute with If the engine overheats, wait for the e If the coolant level is low, it will cause o verheating, and will also cause problems wit h corrosion due t o air entering the coolant. GREASE d noises at the joints. under heavy-duty conditions. Always use the recommended grease and Grease is used to prevent seizure an This construction equipment is used under heavy-duty conditions. Always follow the change intervals and recom mended ambient temperatures given in this Operation and Maintenance Manual. enance section are nipples for overhaul, so they do not need grease. sed for long time, add grease. hat is pushed out when greasing.

The nipples not included in the maint enance section are nipples for overhaul, so t hey do n ot need grease If any part becomes stiff after being u Always wipe off all of the old grease t Be particularly careful to wipe off the old grease in places where sand or dirt sticki ng in the grease would c ause wear of the rotating parts.