. MAINTENANCE SERVICE PROCEDURE 2. When adjusting, loosen 4 bolts (1), turn 2 adjustment bolts (2), and move bracket (3) and the compressor as one unit. 3. After adjusting, tighten bolt (1) and the locknut of bolt (2). NOTICE 723.3 lbft) stud bolt is broken, replace all the stud bolts for that 4 - 42 ADJUSTING 1. Open t he engine side cover on the right side of the machine. Check eac h pulley for damage, w ear of the V-groove, an d wear of th e V-belt.
I n particular, be sure to check that the V-belt is not touching the bottom of the V-gro In case an y of the following occu rs, ask the Komatsu d istributor in your territory to replace the b • The fan belt has elongated, le aving little allowance f or adjustme • A cut o r crack is found on the • Slippin g or creaking sound is heard coming from the When the new V-belt is set, read just it after one hour o f operation. CHECK FOR LOOSE WHEEL HUB BOLTS, TIGHTEN If wheel hu b nuts (1) are loose, t ire wear will be increased and may cause acci dents. 1. Check for loose nuts, and ti When checking for loose directio n of tightening to ch Tightening torque: 785 to 9 578. 6 to 2. wheel.