Komatsu — CHANGE OIL IN TRANSFER CASE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN TRANSFER CASE WARNING engine is stopped, and may cause burns. Wait for the 4 - 48 EVERY 1000 HOURS Maintenance for every 50, 100, 250 and 500 hours se rvice should be carried out at the s temperature to go down be When removing the oil filler cap, turn it slowly to release the internal Refill capacity: 5.5 liters 1. Set a container to cat ch the oil under drain plug (P), then nd drain the oil. 2. remove drain plug (P) a To prevent the oil from (P) and remove it grad After draining the oil, in pouring out suddenly, loosen drain plug ually. stall drain plug (P). 3. 4.

Loosen bolt (1), remov Remove any dirt stuck e cover (2), then take out strainer (3). to strainer (3), then wash it with clean diesel oil or flushing oil with a new part. . If the strainer is damaged, replace it over (2) with a new part, then install. 5. Replace O-ring (4) of c over (2) with a new part, th en install. 6. Refill the specified qua ntity of oil through oil filler ( F). cified level. 7. After filling with oil, che ck that the oil is at the spe cified level. For details, see "CHEC K OIL LEVEL IN TRANSFER CASE, ". ASE, ADD OIL (PAGE 4-23) 8. Check that there is no oil leakage from the transfe r case