Komatsu — REPLACE HST OIL FILTER ELEMENT

. MAINTENANCE SERVICE PROCEDURE REPLACE HST OIL FILTER ELEMENT WARNING cause burns. Wait for the 1. Remove cover (1). NOTICE 4 - 50 T he parts and oil are at high te mperature immediately after the engine is stopped, and may tarting the work. turn it slowly to release the internal pressure, then remove it. temperature to go down before s When removing the oil filler cap, 2. Using a filter wrench, turn filt i 3. Install the new filter cartridg When the packing surface surface of the filter holder, ti Tightening torque: 29 to 39 lbft) When the packing surface surface of the filter holder, ti 4. Run the engine at low idle for HST circuit. 5.

Check that the hydraulic oil is see "CHECK OIL LEVEL I (PAGE 4-38)". 6. Run the engine at low idle, a nd extend and retract the steering, bucket, and lift arm c ylinders 4 to 5 times. Be careful not to operate the cyli nder to the end of its stroke (stop approx. 100 mm (3.9 in) before the end of stroke). If the engine is run immediately at h igh speed or the cylinder is operated to the end of its stroke, th e air inside the cylinder will caus e damage to the piston packing 7. Operate the steering, bucke t, and lift arm cylinders to the end of their stroke 3 to 4 tim es, then stop the engine and loosen filler cap to blee d the air from the hydraulic tank. is at the specified level.

For details, see "CHECK OIL LEVEL IN HYDRAULIC 8)". d operation, install cover (2). 8. Check that the hydraulic oil TANK, ADD OIL (PAGE 4-3 9. After completing the air blee Replace the HST filter element if the HST oil filter clogging warning pilot lamp lights up, ev en if 1000 hours or 1 year has not passed.