Komatsu — CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC FILTER ELEMENT

. MAINTENANCE SERVICE PROCEDURE EVERY 2000 HOURS SERVICE Maintenance for every 50, 100, 250, 500 and 1000 hours service should be carried out at the same time. CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC FILTER ELEMENT WARNING engine is stopped, and may cause burns. Wait for the Refill capacity: 67 liters (17.70 US gal) 4 - 52 T When removing the oil filler cap, turn it slowly to release the internal 1. Lower the bucket horizontally to the ground and apply the p arking brake, then stop the engine. se P) it. en at to ls, IL g, to 00 2. Remove covers (1) and (2). 3. Keep grip (3) pulled, then turn oil filler cap (F) counterclockwi and remove it.

Set a container to catch the oil under drain plug (P). 4. 5. Loosen drain plug (P), drain the oil, then tighten drain plug ( again. 6. Using a filter wrench, turn cartridge (4) to the left to remove 7. Clean the filter holder, fill the new filter cartridge with oil, th coat the seal and thread of the filter cartridge with oil (or co thinly with grease) and install. When installing the seal, tighten it until its surface comes in contact with the filter holder, then tighten it 1/3 turn more. Refill the specified quantity of oil through oil filler (F). 8. 9. Check that the hydraulic oil is at the specified level. For detai see "CHECK OIL LEVEL IN HYDRAULIC TANK, ADD O (PAGE 4-38)". 10.

Run the engine at low idle, and extend and retract the steerin bucket, and lift arm cylinders 4 to 5 times. Be careful not operate the cylinder to the end of its stroke (stop approx. 1 mm (3.9 in) before the end of stroke). NOTICE f the engine is run immediately at high speed or the cylinder is operat ed to the end of its stroke, the air inside the cylinder will caus e damage to the piston packing. 11. Operate the steering, bucket, and lift arm cylinders to the en d of their stroke 3 to 4 times, then stop the engine and loosen filler cap to bleed the air from the hydraulic tank . ed level. For details, see "CHECK OIL LEVEL IN 12.

Check that the hydraulic oil level and add oil to the specifi HYDRAULIC TANK, ADD OIL (PAGE 4-38)". 13. Next, raise the engine speed and follow the procedure in St ep 11 to bleed the air. Repeat this process until no more air comes out. d (2). 14. After completing the air bleed operation, install cover (1) an