Komatsu — CHECK VIBRATION DAMPER

. MAINTENANCE SERVICE PROCEDURE grease on the bearing, so contact your Komatsu distributor for inspection or 4 - 57 CHECKING FUNCTION OF ACC For details of handling the accumul ator, see Section "ACCUMULATOR (PAGE PPC ACCUMULATOR If the engine stops with the work equ ipment raised, and it is impossible to start th e engine ag ain, it is possible as an emergency measure to actuate the valve with the oil pressure stored in the accumulator and lower the work equipment to the ground. 1. Apply the parking brake. 2. Raise the work equipment to the maximum height, then operate the lift arm control lever to HOLD position (b). 3. Stop the engine. 4.

Leave the work equipment lock lever in the FREE position. 5. Check that the area around the machine is safe, then operate the lift arm control lever to FLOAT position (d) and lower the work equipment to a point 1m above the ground. 6. When the lift arm comes to the 1m position, return the lift arm control lever to LOWER position (c), and lower the work equipment slowly to the ground. REMARK Carry out the check within 2 minutes after stopping the engine. If the machine is left with the engine stopped, the accumulator pressure will drop and it will be impossible to check the cause of the problem.

Carry out the check within 2 minute the machine is left with the engi pressure will drop and it will be impos problem. If the work equipment stops while it is moving, the gas pressure in the accumulator has pro Please contact your Komatsu distri Replace the accumulator every 400 CHECK ALTERNATOR, START The brush may be worn or have no repair.

If the engine is started frequently, c CHECK ENGINE VALVE CLEAR ANCE, ADJUST As special tool is required for remov ing and adjusting the parts, request your K omatsu distri butor for service CLEAN AND CHECK TURBOCH ARGER If there is carbon or oil sludge stuck t o the blower impeller, it will lower the performance of the turbocharger or cause it to break, so ask your Komatsu dis tributor to carry out the cleaning. CHECK VIBRATION DAMPER eeling in the outside surface of the rubber. Check that there are no cracks or p If any cracks or peeling are found, c ontact your Komatsu distributor to have the parts replac