GENERAL SERVICE INFORMATION Visual/Physical Engine Compartment Inspection Perform a careful visual and physical engine compart- ment inspection when performing any diagnostic proce- dure or diagnosing the cause of an emission test failure. This can often lead to repairing a problem without further steps. Use the following guidelines when performing a visual/physical inspection: Inspection all vacuum hoses for punches, cuts, dis- connects, and correct rouring. Inspect hoses that are difficult to see behind other components.
Inspect all wires in a engine compartment for prop- er connections, burned or chafed spots, pinched wires, contact with sharp edges or contact with hot exhaust manifolds or pipes. Basic Knowledge of Tools Required Notice: Lack of basic knowledge of this powertrain when per- forming diagnostic procedures could result in an incor- rect diagnosis or damage to powertrain components. Do not attempt to diagnose a powertrain problem without this basic knowledge. A basic understanding of hand tools is necessary to ef- fectively use this section of the Servise Manual Self Diagnostic System Check Self Diagnostic System should be checked as follows: 1.
When Ignition key is turned from the “OFF” to the “ON” position, make sure that Malfunction Indicator Lamp (MIL) is lit for 0.3 — 0.8 sec. 2. Connect Scan Tool and check to see if MIL is al- ways lit. If so, Self Diagnostic System is normal.