Play in Axial Clearance Moving the rotor in the axial clearance, measure the play by a dial gage. Oil Leakage Check 1. Remove the charge air pipe connecting hose to the compressor side of the turbocharger. 2. Clean the area around the compressor wheel. 3. Remove the blow-by hose. 4. Start the engine and let idle. Rev the engine and hold at wide open throttle (WOT) for five seconds, then release and let idle for five seconds. Repeat this cycle for a total of five times then let the engine idle steady for five minutes. 5. Shut off the engine. 6. Check the compressor area for an oil stream. Measure the play at several points while letting the rotor revolve.
Attach the turbocharger and dial gage firmly. If excessive, replace the turbocharger. Caution: A stream of oil indicates a possible defective turbo- charger. If mist or spray is present, however, this is normal and is NOT indicative of a turbocharger problem. 7. If the turbocharger is suspect, refer to the on-vehi- cle service procedures in this section. Installation 1. Exhaust manifold to turbocharger. 2. New gasket and turbocharger to exhaust manifold. Tighten: Turbo charger to 52 N m (5.3 kg m/ 38 lb ft) Operation of Waste Gate N6A1378E Disconnect hose (2) from waste gate (1), and in- stall pressure gauge (3) as shown in the figure.
With the engine stopped, operate the pressure gauge pump to apply pressure to the waste gate for check the waste gate function. 3. Tighten the cylinder head to turbinhousing and ex- haust manifold to the specified torque in the nu- merical order shown in the illustration. (4HG1-T) N6A1380E Tighten: Exhaust manifold to 34 N m (3.5 kg m/ 25 lb ft) N6A1379E Play in axial clearance mm (in) Standard Limit 0.013 — 0.097 (0.0005 — 0.0038) 0.097 (0.0038)