Isuzu — Isuzu N Series Training Manual

Substandard or Contaminated Fluid Notice: Hydraulic brake systems use two distinct and incompat- ible fluids. Power steering fluid is used in the hydraulic booster brake system. Brake fluid is used in the master cylinder and brake pipes to the wheels. Be extremely careful when selecting brake system fluids or seal dam- age can result. Refer to Section 0B MAINTENANCE AND LUBRICATION to select the correct fluid. Notice: Do not reuse brake system fluids. Do not mix power steering fluid with brake fluid. Swelling and deterioration of rubber parts can result from fluid contamination. This can lead to reduced brake performance and the eventu- al loss of braking capability.

Contaminated fluid causes swelling and deterioration of rubber parts that can lead to reduced brake perfor- mance and the eventual loss of braking capability. Check the condition of the fluid at regular intervals and note any unusual consistency, color, and signs of con- taminants in the fluid. Do not reuse brake system fluids. Always discard used fluids. Do not mix power steering fluid with hydraulic brake fluid. If contamination occurs, flush the hydraulic booster system with clean power steering fluid. Booster components bench servicing should be done in a clean work area separated from the brake servicing ar- ea. Wash hands before changing between brake or booster work areas.

Do not use the same containers for fluids. Flushing the Hydraulic Booster System Flushing is required when dirt, sludge, or water is found in the system. Flushing involves running clean fluid through the system until the draining fluid appears the same as clean fluid. Contaminated fluid in the booster system can cause rub- ber parts to deteriorate. The hydraulic booster system should be cleaned and flushed when the hydraulic pump is replaced. Metal shavings from a worn hydraulic pump often con- taminate the system. Pipes and hoses should be re- moved and blown clean of all metal shavings.