6. Remove the rear oil seal using the flat-tip screw- driver. Installation 1. Apply engine oil 5W-30 around a new oil seal, and then press in the oil seal to the rear cover using the installer 5-8840-2750-0. Caution: Be careful not to damage the lip of the oil seal. Apply Besco L2 grease on the lip of the oil seal. N7A0294E After fixing it to the specified torque, align the lip part of the nut to the V-groove of the shaft edge. Securely caulk the two parts of the nut lip using a chisel whose tip form is approx. 1 mm (0.04 in) radius by 60 ° , to make a length (B) of 5 mm (0.2 in) or more, and a clearance between the bottom of the shaft and the nut lip (A) of 1.5 mm (0.06 in) or less.
Caution: If any crack is found on the caulking portions of the nut after the check, replace the lock nut and caulk it again. 2. Install the parking brake assembly. N7A0295E Refer to PARKING BRAKE ASSEMBLY. 3. Install the coupling driver. a. Apply engine oil 5W-30 to the O-ring, and then install the coupling driver and the O-ring. b. Use a new lock nut and apply engine oil 5W-30 on its seat, and then fix the lock nut using the flange holder 5-8840-2043-0. MIN 5.0mm Tighten: Lock nut to 289 N m (29.5 kg m / 213 lb ft) B MIN 5.0mm MAX 2.5mm A MAX 2.5mm N7A0297E