3. Move the disc one complete rotation. The lateral runout should not exceed 0.13 mm (0.005 in). 1 2 Parallelism and thickness Parallelism is the measurement of the thickness of the disc at four or more points around the circumference of the disc. All measurement must be made at 29 mm (1.14 in) from the edge of the disc. The disc thickness must not vary more than 0.010 mm (0.0004 in) from the point to point. N5A0433E Legend 1. Piston Seal 2. Body Assembly 2. Piston 3. Piston Boot 4. Boot Ring 1) Apply brake oil to the piston outer circumfer- ence. 2) Use a hand vise to install the pistons to the cyl- inder. Installation N5A0072E 1. Piston Seal 1) Apply rubber grease to the piston seal.
The rubber grease is included in the seal kit. 2) Install the piston seal to the cylinder bore groove. N5A0075E 3) Apply special grease to the piston. This will prevent cylinder and piston corrosion. 4) Install the piston boot outer lip to the cylinder bore groove. Install the piston boot inner lip to the piston groove. Handle the piston boot carefully. Maximum runout mm (in) 0.13 (0.005) Maximum parallelism mm (in) 0.02 (0.0008) Disc Thickness mm (in) Standard Limit 35.0 (1.378) 32.0 (1.260)