Isuzu — Isuzu N Series Training Manual

Accumulator and O-ring Replacement Removal Tighten: Accumulator to 29 N m (3.0 kg m / 22 lb ft) BIock the vehicle and apply the parking brake. 4. Install ventilation duct. 5. Connect harness connector and install meter as- sembly. 6. Install meter cluster. 7. Connect the battery ground cable. 8. After attaching it to the vehicle, always replenish with new hydraulic oil (ATF DEXRON ® -III), and completely release the air from the hydro boost. 9. Release the parking brake and remove the wheel blocks. Disconnect the battery ground cable.

Reduce the pressure of the hydraulic oil in the ac- cumulator by brake pedal operation with the engine off, and after confirming that the temperature of the hydro boost assembly has been reduced, remove the hydro boost assembly from the vehicle. 1) Remove meter cluster. 2) Remove meter assembly and harness connec- tor. 3) Remove ventilation duct. 4) Using an oil filter wrench, remove accumulator and O-ring. Notice: How to dispose of the accumulator To dispose of the accumulator, drill a hole in the position shown in the diagram according to the indications print- ed on the accumulator, completely release the nitrogen gas scaled inside the accumulator, then dispose of the accumulator.

Concerning disposal with the hydro boost assembly as well, dispose of it after first letting out all the nitrogen gas inside the accumulator, by the above method. N5A0010E Legend 1. Accumulator 2. Stud bolt 3. Cover boss 4. Lock nut 5. Clevis 6. Operating rod 7. Guard 8. Flange N5A0216E Legend 1. Accumulator 2. HEX25 3. Thread 4. O-ring 5. Drilling point for gas releasing Installation 1. Verify that there is no foreign matter adhering to the screw part of the accumulator or to the attach- ment part on the booster side. 2. Put an O-ring coated with new hydraulic oil (ATF DEXRON ® -III) into the screw part of the accumula- tor, being careful not to damage it. Always use a new O-ring. 3.

Using an oil filter wrench, hold the accumulator shell fixed, and tighten it via the wrench to the specified torque.