Tech 2 Features 1. Tech 2 is a 12 volt system. Do not apply 24 volt. 2. After connecting and/or installing the Vehicle Com- munications Interface (VCI) module, PCMCIA card and DLC connector to the Tech 2, connect the tool to the vehicle DLC. 3. Make sure the Tech 2 is powered OFF when re- moving or installing the PCMCIA card. 4. The PCMCIA card has a capacity of 10 Megabytes which is 10 times greater than the memory of the Tech 1 Mass Storage Cartridge. (except 2003 year model) 5. The Tech 2 has the capability of two snapshots. 6. The PCMCIA card is sensitive to magnetism and static electricity, so care should be taken in the handling of the card. 7.
The Tech 2 can plot a graph when replaying a snapshot. 8. Always return to the Main Menu by pressing the EXIT key several times before shutting down. 9. To clear Diagnostic Trouble Codes (DTCs), open Application Menu and press “F1: Clear DTC Info”. Tech Tech 2 Press [ENTER] to continue. Software Version: X.XXX N5A1006E Notice: The RS232 Loop back connector is only to use for diag- nosis of Tech 2. Refer to user guide of the Tech 2. Getting Started Before operating the Isuzu PCMCIA card with the Tech 2, the following steps must be performed: 1. The Isuzu System PCMCIA card (1) inserts into the Tech 2 (5). 2. Connect the SAE 16/19 adapter (3) to the DLC ca- ble (4). 3.
Connect the DLC cable to the Tech 2 (5). 4. Make sure the vehicle ignition is off. 5. Connect the Tech 2 SAE 16/19 adapter to the ve- hicle DLC. N5A1005E 6. Turn on the vehicle ignition. 7. Power the Tech 2 ON and verify the Tech 2 power up display.