Isuzu — Isuzu N Series Training Manual

Chart B-1-1 With the key in the ON position (Before starting the engine). Warning light (W/ L) is not activated. Step Action Value(s) YES NO 1 Is W/L fuse F-16 blown out? — Go to Step 5 Go to Step 2 2 Is W/L bulb burnt out? — Go to Step 6 Go to Step 3 3 1. Turn the key off. 2. Disconnect EHCU connectors. 3. Turn the key on. 4. Using DVM, measure the voltage be- tween J-177 EHCU connector terminals 6 and 1. Does the DVM display a voltage within the specified value? 12V: 9.5 — 16.5 V 24V: 16.5 — 34 V Go to Step 4 Go to Step 7 4 Check the continuity between J-177 EHCU connector terminal 1 and body ground. Is there continuity? — Go to Step 9 Go to Step 8 5 Replace the fuse. Is action complete?

— Go to Step 10 — 6 Replace the W/L bulb. Is action complete? — Go to Step 10 — 7 Locate and repair open circuit, poor connec- tion or short circuit in the ignition feed circuit. Is action complete? — Go to Step 10 — 8 Locate and repair open circuit, poor connec- tion or short circuit in the ground circuit. Is action complete? — Go to Step 10 — 9 1. Check the harness for suspected discon- nection. 2. If no fault found, replace the EHCU. Is action complete? — Go to Step 10 — 10 1. Reconnect all components, ensure all components are properly mounted. 2. Clear diagnostic trouble code. Was this step finished? — Go to “Basic diag- nostic flow chart”. —