Chart 12 (DTC54/C0254) RR Speed Sensor Circuit Abnormality Step Action Value(s) YES NO 1 1. Turn the key off. 2. Disconnect EHCU connector J-177 and RL speed sensor connector J-148 (J-78). 3. Check the continuity between connector J-177 terminal 12 and sensor connector J-148 (J-78) terminal 1 (3). Is there continuity? — Go to Step 2 Go to Step 7 2 Check the continuity between connector J-177 terminal 12 and connector J-177 terminal 1. Is there continuity? — Go to Step 7 Go to Step 3 3 Check the continuity between connector J-177 terminal 21 and sensor connector J-148 (J-78) terminal 2 (4). Is there continuity?
— Go to Step 4 Go to Step 7 4 Check the continuity between connector J-177 terminal 21 and connector J-177 terminal 1. Is there continuity? — Go to Step 7 Go to Step 5 5 1. Connect the connector J-177 with EHCU. 2. Turn the key on. 3. Using DVM, measure the voltage be- tween connector J-148 (J-78) terminal 2 (4) (vehicle side) and ground. Does the DVM display a voltage within the specified value? 9 — 16 V Go to Step 6 Go to Step 7 6 Check the RL sensor output. (Refer to Chart C-1-4) Does the DTC repeat? — Go to Step 8 Go to Step 9 7 Repair open circuit, poor connection and/or short circuit between the EHCU connectors and speed sensor connectors. Is this step complete?
— Go to Step 9 — 8 Replace EHCU. Is this step complete? — Go to Step 9 — 9 1. Reconnect all components, ensure all components are properly mounted. 2. Clear diagnostic trouble code. Was this step finished? — Go to “Basic diag- nostic flow chart”. —