Isuzu — Isuzu N Series Training Manual

N5A1039E Legend 1. Battery 3. Resistor 2. DVM 4. Speed Sensor Step Action Value(s) YES NO 2 1. Turn the key off. 2. Disconnect RL sensor connector. 3. Connect a 120 ohms resistor between sensor connector terminal 2 (sensor side) and ground. 4. Apply 12 V voltage at sensor connector terminal 1 (sensor side). 5. Using DVM, measure the DC voltage be- tween sensor connector terminal 2 (sen- sor side) and ground while turning RL wheel at a speed of 0.5 RPS. Does the DVM display a voltage within the specified value? 0.2 — 4.5 V Go to Step 3 Go to Step 4 3 1. Locate open circuit, poor connection short circuit on the harness between EHCU and sensor connectors. 2. Repair the harness.

Is action complete? — Go to Step 5 — 4 Replace RL sensor. Is action complete? — Go to Step 5 — 5 1. Reconnect all components, ensure all components are properly mounted. 2. Clear diagnostic trouble code. Was this step finished? — Go to “Basic diag- nostic flow chart”. —