Notice: Correct the drum inside diameter by grinding to the ap- propriate limit. Notice: Confirm that the portion indicated by the arrow is prop- erly connected. Installation 1. Mount the parking brake lever assembly. Mount the parking brake lever assembly, connect the parking brake cable, and properly tighten the adjusting nut. N5A0341E 4. Mount the coupling driver. Attach the coupling driver to the main shaft, and fasten it with an O-ring, a conical washer (MSB only), and a lock nut. Tighten the lock nut while holding the coupling driv- er with a handle 5-8840-2043-0. N5A0342E 2. Mount the parking brake assembly. Tighten:
M12 nut to 113 N m (11.5 kg m/83.3 lb ft) M8 bolt to 25 N m (2.6 kg m/18.4 lb ft) 178 mm type parking brake 190 mm type parking brake Wash the stud bolt and the bolt hole with vola- tile oil (thinner, alcohol, etc.). Apply Loctite #638 to the embedded side (guide side) of the stud bolt and the bolt hole. Attach the stud bolt (M12). Tighten: Stud bolt to 49 N m (5.0 kg m/36.1 lb ft) Mount the parking brake assembly, and fasten it with the caulking nut (M12). Tighten: Caulking nut to 126.5 N m (12.9 kg m/93.3 lb ft) 203 mm type parking brake Tighten: 127 N m (13.0 kg m/93.7 lb ft) 3. Connect the parking brake cable.
Connect the parking brake cable to the lever of the parking brake assembly (178, 190 mm TYPE). N5A0346E Notice: Use a new lock nut because it is a caulking type. Apply oil to the seating face before attaching the lock nut. Tightening torque N⋅m (kg⋅m/lb⋅ft) MSB type transmission 226 (23.0/166.7) MYY type transmission 289 (29.5/213.2) MZZ type transmission 382 (39.0/281.8)