Isuzu — Isuzu N Series Training Manual

Diagnostic basic flow Function Check EHCU Connector Pin Arrangement N5A2018E Step Action Value YES NO 1 1. Complaint from the customer 2. Interview to the customer. 3. Perform the basic inspection. (Refer to “Brake basic inspection”.) Is Tech 2 required? — Go to Step2 Go to Step3 2 Check DTC. Is DTC appeared? — Go to Step5 Go to Step4 3 Check DTC (with warning lamp illumination pattern). Is DTC appeared? — Go to Step5 Go to Step4 4 Test run the vehicle. Does the warning lamp come on? — Go to Step5 Refer to “List of trouble symp- tom”.Go to Step5 5 1. Repair the trouble part. 2. Clear the DTC. 3. Check the ABS warning lamp for illumina- tion pattern with the ignition switch ON. 4.

Test run the vehicle. Is the trouble appeared again? — Repeat the “Diag- nostic basic flow” if the trouble appeared again (with trouble symptom or DTC). Go to Step1 Go to Step6 6 1. Install all the components, and check that those are installed properly. 2. Clear the DTC. Is this step completed? — End. Go to Step6