Data display Example N5A2024E DTC is the language for technicians to communicate with the ECM on the vehicle. DTC can roughly be classified into past DTC and current DTC. Current DTC: Trouble (fault) occurred current igni- tion cycle Past DTC: Trouble (fault) occurred previous igni- tion cycle or that in the past Multiple DTC: More than one DTC may be dis- played in a time. It is called as multiple DTC. This happens when multiple troubles (faults) occurred in a time. Further this happens to the sensors and switches sharing same power source or ground. When such power source or ground is open or shorted, the DTCs of relevant sensors or switches are displayed.
In this case, the power source or ground shared must be checked for open/short circuit. Use of DTC clear mode can erase the DTC mem- ory stored in the vehicle. N5A2025E Use of this menu can display the current data. Note that menu is subject to change. CAUTION: On the vehicle that the rear tires have smaller diameter, the rear wheel speed may be indicated a little higher than the front wheel speed. Check the speed after driv- ing a while at a constant speed.