DTC:C0213 (Flash Code 13) Model Type Identification Fault Due to Wrong Assembly of Control Unit Step Action Value YES NO 1 1. Turn the starter switch OFF. 2. Disconnect the J-177 connector of the EHCU. 3. Turn the starter switch ON. Measure the voltage between the J-177 con- nector terminal 18 and the 1,23. Is the voltage within the specified value? 0.5 — 4.5V Go to Step2 Go to Step3 2 Repair the short circuit and improper connec- tion in J-177 connector terminal 18. Measure the voltage between the J-177 con- nector terminal 18 and 1,23. Is the voltage within the specified value? 0.5 — 4.5V Go to Step3 Go to Step4 3 1. Install all the components, and check that those are installed properly.
2. Clear the DTC. 3. Does failure occur? Is this step completed? — Go to “Diagnostic basic flow”. Go to Step4 4 Replace the EHCU with a new one. Is this step completed? — Go to “Diagnostic basic flow”. Go to Step3