Isuzu — Isuzu N Series Training Manual

DTC:C0252 (Flash Code 52) Speed Sensor Open/Short Circuit; FR Check flow B-14 Step Action Value YES NO 1 1. Turn the starter switch OFF. 2. Disconnect the connector of the EHCU. 3. Measure the resistance between the J- 177 connector terminals 10 and 11. Is the value within specified value? 1 — 2kΩ Go to Step2 Go to Step3 2 Measure the resistance between the J-177 connector terminals 10 and the ground. Is the value within specified value? 1000kΩ or more Go to Step7 Go to Step4 3 1. Disconnect the FR wheel speed sensor connector. 2. Measure the resistance between the J-74 connector terminals 1 and 2 (sensor side). Is the value within specified value? 1 — 2kΩ Go to Step5 Go to Step6 4 1.

Disconnect the FR wheel speed sensor connector. 2. Measure the resistance between the J-74 connector terminal 1 (sensor side) and the ground. Is the value within specified value? 1000kΩ or more Go to Step5 Go to Step6 5 Repair the circuit for open/short circuit between the control unit connector and the sensor connector. Is this step completed? — Go to Step8 — 6 Replace the FR control unit. Is this step completed? — Go to Step8 — 7 Replace the control unit. Is this step completed? — Go to Step8 — 8 1. Install all the components, and check that those are installed properly. 2. Clear the DTC. Is this step completed? — Go to “Diagnostic basic flow”. Go to Step8