Isuzu — Isuzu N Series Training Manual

DTC:C0263 (Flash Code 63) Speed Sensor Signal Fault/Wrong Tire Size; RL Check flow B-19 Step Action Value YES NO 1 Check the tire. Is the tire specification correct? Is abnormal wear found in the outer surface? — Go to Step2 Replace with the specified tire with- out wear.Go to Step18 2 Has certain tire been rotated alone by perfum- ing for jack-up or roller tester? — DTC may be set if certain tire is rotated alone. Go to Step18 Go to Step3 3 Is the FL wheel bearing rattling? — Go to Step10 Go to Step4 4 Is the FL wheel speed sensor/sensor rotor rat- tling? — Go to Step11 Go to Step5 5 Is iron powder attached to the FL wheel speed sensor/sensor rotor?

— Go to Step12 Go to Step6 6 Check the RL wheel speed sensor. (Refer to the check flow C-1-3.) Is the RL sensor output normal? — Go to Step7 Go to Step9 7 Does the sensor rotor have missing tooth or saw-toothed? — Go to Step13 Go to Step8 8 1. Clear the DTC. 2. Test run the vehicle, and perform the self- diagnosis. Is DTC displayed repeatedly? — Go to Step17 Go to Step16 9 Is the speed sensor damaged or saw- toothed? — Go to Step14 Go to Step15 10 Adjust the preload of the wheel bearing. Is this step completed? — Go to Step18 — 11 Repair or replace the speed sensor/sensor rotor. Is this step completed? — Go to Step18 — 12 Repair the speed sensor/sensor rotor. Is this step completed?

— Go to Step18 — 13 Replace the sensor rotor. Is this step completed? — Go to Step18 — 14 Replace the RL wheel speed sensor. Is this step completed? — Go to Step18 — 15 Check the RL wheel speed sensor circuit. (Refer to the check flow B-15.) Is this step completed? — Check the repair. — 16 Check the circuit for open circuit, and the con- nector for improper connection the EHCU connector and the speed sensor connector. Refer to “Intermittent trouble”. Is this step completed? — Go to Step18 —