Symptom: [Brake Operating Noise Comes from the Hydraulic Unit Though the Brake Pedal is not Depressed.] (Check Flow A-5, TA-5) Check flow A-5, TA-5 Step Action Value YES NO 1 Is this the first time operation since the engine is started? — Normal (It is a motor check oper- ation noise of self- diagnosis func- tion.) Go to Step2 2 Is the vehicle speed 10km/h (6 mph) or less? — Normal (It is a motor check oper- ation noise of self- diagnosis func- tion.) Go to Step3 3 Check for noise in the following conditions:
• When shifting down, or when operating the clutch • When driving a slippery low-temperature road (iced or snow-covered), or when driv- ing a rough road • While turning with high speed • When driving over a bump (such as curb- stone) • When operating electrical switches • When running the engine high speed Is noise generated in any of the above condi- tions? — Normal (ABS may operate without depressing the brake pedal.) Go to Step4 4 Do all the speed sensor/sensor rotor operate normally? — Go to Step5 Repair.Go to Step7 5 Is the wheel speed sensor/sensor rotor dam- aged? Or iron powder attached? — Go to Step7 Repair or replace it.Go to Step6 6 Are all the sensor outputs normal?
(Refer to the check flow C-1 or TC-1) — Check the suspi- cious circuit/con- nector for improper connec- tion. If the connec- tion is normal, replace the EHCU.Go to Step7 Repair.Go to Step7 7 Assemble all the components, and check that those are installed properly. Is this step completed? — Repeat “Diagnos- tic basic flow”. Go to Step7