Isuzu — Isuzu N Series Training Manual

Speed Sensor Output Check Procedure Check flow TC-1 Used for checking the front speed sensor, or the rear speed sensor when no DTC is set. CAUTION: On the vehicle that the rear tires have smaller diameter, the rear wheel speed may be indicated a little higher than the front wheel speed. Check the speed after driv- ing a while at a constant speed. Step Action Value YES NO 1 1. Connect the Tech 2. 2. Check each sensor lowest speed from the “Wheel sensor”. Is the sensor speed 4km/h (2 mph) or more? — Go to Step2 Go to Step6 2 Check the suspicious sensor circuit for open circuit. (Check with shaking the wire and the connector.) Is the sensor circuit connection normal?

— Replace the speed sensor.Go to Step3 Repair.Go to Step2 3 Check each sensor lowest speed from the “Wheel sensor”. Is the sensor speed 4km/h (2 mph) or more? — Go to Step4 Go to Step6 4 Check the sensor rotor. Is the sensor rotor normal? — Go to Step5 Replace the sen- sor rotor. Go to Step5 5 Check each sensor lowest speed from the “Wheel sensor”. Is the sensor speed 4km/h (2 mph) or more? — Repair the circuit or connector between the EHCU and the speed sensor. Go to Step6 Go to Step6 6 Install all the components, and check that those are installed properly. Is this step completed? — Repeat “Diagnos- tic basic flow”. Go to Step6