Isuzu — Isuzu N Series Training Manual

4.

Quick-on Start System Checkpoint Possible cause Correction Injection nozzle Injection nozzle sticking Replace the injection nozzle Injection nozzle injection starting pressure too low Improper spray condition Adjust or replace the injection nozzle Injection pump Defective fuel injection nozzle resulting in the fuel drippage after fuel injection Replace the delivery valve Defective injection pump control rack oper- ation Repair or replace the injection pump con- trol rack Injection pump plunger worn or stuck Replace the injection pump plunger assembly Injection pump drive shaft seizure or other damage Replace the injection drive shaft Injection pump governor spring seizure Replace the injection pump governor spring Check point Possible cause Correction Glow plug indicator light does not turn on 1.

Defective Fusible link wire 2. Broken indicator light fuse 3. Defective indicator bulb Replace the fusible link wire Replace the indicator light fuse Replace the indicator light bulb Preheating system dose not work 1. Defective fusible link wire shorted 2. Defective glow plug relay connector 3. Defective glow plug connector 4. Defective quick-on start timer connec- tor Replace the fusible link wire Replace or Repair glow plug relay connec- tor Replace or Repair glow plug connector Replace or Repair quick-on start timer connector Preheating time to long or to short 1. Defective thermo switch include defec- tive wiring harness 2. Defective glow plug 3.

Defective timer unit Replace thermo switch Replace glow plug Replace timer unit