Insufficient Power Check point Possible cause Correction Air cleaner Clogged air cleaner element Clean or replace the air cleaner element Fuel Water particle in the fuel Replace fuel Fuel filter Clogged fuel filter element Replace the fuel filter element or the fuel filter cartridge Fuel feed pump Defective fuel feed pump Repair or replace the fuel feed pump Injection nozzle Injection nozzle sticking Replace the injection nozzle Injection nozzle injection starting pressure too low Improper spray condition Adjust or replace the injection nozzle Fuel injection pipes Fuel injection pipes damaged or obstructed Replace the fuel injection pipes Injection pump Defective regulating valve Repair or replace the regulating valve Defective delivery valve Replace the delivery valve Defective timer Repair or replace the timer Worn cam disk Replace the cam disk Improper control lever operation Adjust or replace the control lever Defective injection timing Adjust the injection timing Repair or replace the injection pump timer Weak governor spring Replace the governor spring Worn plunger Replace the plunger assembly Compression pressure Blown out cylinder head gasket Worn cylinder liner Piston ring sticking Replace the related parts Valve clearance Valve clearance improperly adjusted Adjust the valve clearance Valve spring Valve spring weak or broken Replace the valve spring Exhaust system Exhaust pipe clogged Clean the exhaust pipe Full load adjusting screw seal Open and improperly set adjusting screw seal Adjust and reseal the adjusting screw