Isuzu — Isuzu N Series Training Manual

N6A0109E N6A0111E 2) Apply a coat of engine oil to the bearing cap bolt and stud threads. 3) Tighten the bearing cap bolts and studs to the specified torque. 7. Rocker Arm Shaft Assembly 1) Temporarily tighten the bolts marked with the arrow in the illustration. Tighten: Camshaft bearing cap nut and bolt to 27 N m (2.8 kg m / 20 lb ft) N6A0112E 2) Loosen the rocker arm adjust screws and apply engine oil to the rocker arm roller portions. 3) Install the rocker arm assembly on the cylinder head. 4) Tighten the rocker arm shaft bracket nuts and bolts to the specified torque in numerical order a little at a time as shown in the illustration. N6A0110E 6.

Valve Cap Apply engine oil to the inside of the valve caps and install them to the valve stem end. Caution: Take sufficient care not to let valve caps fall into the gear. Tighten: Rocker arm shaft bracket nut and bolt to Nut (A): 27 N m (2.8 kg m / 20 lb ft) Bolt (B): 56 N m (5.7 kg m / 41 lb ft) Bolt (C): 27 N m (2.8 kg m / 20 lb ft)