N6A0123E (Measuring Method-II) 1. Measure the valve stem outside diameter. Refer to the “Valve Stem Outside Diameter”. 2. Use a caliper calibrator or a telescoping gauge to measure the valve guide inside diameter. 3. Calculate the clearance between the valve guide inside diameter and the valve stem outside diame- ter. If the clearance exceeds the specified limit, the valve and the valve guide must be replaced as a set. N6A0125E Valve Guide Replacement Valve Guide Removal Use a hammer and the valve guide replacer to drive out the valve guide from the cylinder head lower face. Valve Guide Replacer:
5-8840-2227-0 N6A0124E Valve Stem Outside Diameter Measure the valve stem diameter at three points. If the measured valve is less than the specified limit, the valve and the valve guide must be replaced as a set. N6A0126E Valve Guide Installation 1. Apply engine oil to the valve guide outer circumfer- ence. 2. Attach the valve guide installer to the valve guide. Valve Guide Replacer: 5-8840-2227-0 Valve Stem Outside Diameter mm (in) Valve Standard Limit Intake Valve 8.946 — 8.962 (0.3522 — 0.3528) 8.88 (0.350) Exhaust Valve 8.921 — 8.936 (0.3512 — 0.3529) 8.80 (0.346)