Isuzu — Isuzu N Series Training Manual

N6A0217E N6A0208E 7. Tighten the crankcase to the specified torque in the numerical order shown in the illustration. Do not allow the crankshaft to turn during bearing cap installation and tightening. 8. Remove the bearing beam and the crankcase with bearings. 9. Compare the width of the Plastigage attached to ei- ther the crankshaft or the bearing with the scale printed on the Plastigage container. Tighten: Crankcase bolt (M14: (1) — (10)) to 1st step: 98 N m (10 kg m / 72 lb ft) 2nd step: 132 N m (13.5 kg m / 98 lb ft) 3rd step: 30 — 60 ° N6A1415E Tighten: Crankcase bolt (M10: (1) — (17)) to 3.9 ± 0.7 N m (28 ± 5 kg m / 38 ± 7 lb ft) N6A0219E 10.

If the measured value exceeds the limit, perform the following additional steps. Crankshaft Journal and Bearing mm (in) Clearance Standard Limit No.1, 2, 4 and 5 Journal 0.037 — 0.072 (0.0015 — 0.0028) 0.11 (0.0043) No.3 Journal 0.051 — 0.086 (0.0020 — 0.0034) 0.11 (0.0043)