If an inside dial indicator is not available, use the follow- ing procedure to check the piston pin clearance. 1. Use a piston heater to heat the piston to approxi- mately 80 — 100 ° C (176 — 212 ° F) 2. Push strongly against the piston pin with your thumbs. The piston pin should move smoothly with little or no resistance. N6A0261E N6A0263E Connecting Rod Connecting Rod Alignment Use a connecting rod aligner to measure the distortion and the parallelism between the connecting rod big end hole and the connecting rod small end hole. If either the measured distortion or parallelism exceeds the specified limit, the connecting rod must be replaced.
Piston Pin Hole and Piston Pin Clearance Use an inside dial indicator to measure the piston pin hole (in the piston). N6A0262E Piston Pin Diameter mm (in) Engine model Standard Limit Except 4HE1- TC 35.995 — 36.000 (1.4171 — 1.4173) 35.970 (1.4161) 4HE1-TC 39.995 — 40.000 (1.5746 — 1.5748) 39.970 (1.5736) Piston Pin Hole and Pis- mm (in) ton Pin Clearance Standard Limit 0.004 — 0.017 (0.00016 — 0.00067) 0.04 (0.0016) Connecting Rod Alignment mm (in) Per Length of 100 (3.94) Standard Limit Distortion 0.05 (0.002) or less 0.20 (0.008) Parallelism