Cylinder Liner Grade Selection and Standard Fitting Interference Accurately measured fitting interference and proper cyl- inder liner grade selection are extremely important. If the cylinder liner fitting interference is too small, en- gine cooling efficiency will be adversely affected. If the cylinder liner fitting interference is too large, it will be difficult to insert the cylinder liner into the cylinder body. A mark was stamped on the left side of the cylinder block during production to indicate the correct liner. The liner grade (i.e.1, 2, 3) is indicated in metal stamp.
N6A0300E Cylinder Liner Replacement Cylinder Liner Removal If could not be removed cylinder liner, it is recommended to remove it by following procedure. 1. Set the cylinder liner remover (1) to the cylinder lin- er (3). 2. Check to see if the remover shaft ankle (2) is firmly gripping the cylinder liner bottom edge. 3. Slowly turn the remover shaft handle (4) clockwise to pull the cylinder liner free. Cylinder Liner Remover: 9-8523-1169-0 Cylinder Liner Remover Ankle: 5-8840-2220-0 Ankle: 5-8840-2397-0 (4HG1) N6A0302E Cylinder Liner Grade 4HF1 / 4HF1-2 N6A0301E Caution: Take care not to damage the cylinder body upper face during the cylinder liner removal procedure.
Line Grade Cylinder Bore Diameter mm (in.) Service Grade Liner Outside Diameter mm (in.) 1 115.001 — 115.010 (4.5276 — 4.5279) 1X 114.991 — 115.000 (4.5272 — 4.5276) 2 115.011 — 115.020 (4.5280 — 4.5283) 3X 115.001 — 115.010 (4.5276 — 4.5279) 3 115.021 — 115.030 (4.5284 — 4.5287)