N6A0307E N6A0308E The piston grade (i.e. A, B, C) is indicated in metal stamp on the piston upper face. Legend 1. Part No. 2. Grade 3. Front mark Caution: Cylinder liner kit clearances are preset. However, the cylinder liner installation procedure may result in slight decreases in cylinder liner clearances. Always measure the cylinder liner clearance after installation to be sure that it is correct. Reassembly 1. Cylinder Block Use compressed air to thoroughly clean the inside and outside surfaces of the cylinder body, the oil holes, and the water jackets. 2. Piston Oiling Jet 1) Install the oiling jets together with the check valves. Take care not to damage the oiling jet nozzles.
2) Tighten the check valves and oiling jets to the specified torque. Tighten: Check valve and oiling jet to 21 N m (2.1 kg m / 15 lb ft) Piston Grade Engine Model Cylinder Liner Bore Diameter mm (in) Piston Service Grade Piston Out- side Diameter mm (in) 4HF1 4HF1-2 112.041 — 112.060 (4.4111 — 4.4118) — 111.944 — 111.959 (4.4072 — 4.4078) 4HG1 4HG1-T 115.041 — 115.060 (4.5292 — 4.5299) — 114.944 — 114.959 (4.5253 — 4.5259) 4HE1- TC 110.066 — 110.075 (4.3333 — 4.3337) AX 109.944 — 109.959 (4.3285 — 4.3291) 110.076 — 110.085 (4.3337 — 4.3340) CX 109.960 — 109.975 (4.3291 — 4.3297)