Isuzu — Isuzu N Series Training Manual

1207C) or its equivalent on the groove of the water suction pipe fitting surface. 2) Install the water suction pipe to the oil cooler. For the dislocation of liquid gasket, refer to the illustration. N6A1626E Legend 1. O-ring 2. Liquid gasket N6A1627E Notice: Take care that the O-ring is not smeared with liquid gas- ket. Legend 1. Liquid gasket Install it within 7 minutes after application of liq- uid gasket. For the dislocation of liquid gasket, refer to the illustration. 3) Tighten the oil cooler bolts and nut to the spec- ified torque a little at a time in the sequence shown in the illustration. Tighten: Water suction pipe bolt and nuts to 24 N m (2.4 kg m / 17 lb ft) Notice:

Install the water suction pipe immediately after the in- stallation of the oil cooler. Tighten: Oil cooler bolt and nut to 24 N m (2.4 kg m / 17 lb ft) N6A0322E N6A0320E 37. Heater Pipe 1) Install the O-ring to the heater pipe. 2) Install the heater pipe to the oil cooler. 36. Water Suction Pipe 1) Apply 2 — 3 mm (0.08 — 0.12 in) bead of the recommended liquid gasket (Three Bond