2) Disconnect Injection Pipe. 3) Put down Wax CSD lever, insert a spacer 10 — 20 mm (0.39 — 0.47 in) thick between the plunger and adjust bolt, and cancel the Wax CSD. 7) Turn the crankshaft leftwise and rightwise a lit- tle and make sure that the needle stays in the “0” position. N6A0059E N6A0057E 8) Turn the crankshaft in the normal direction and read the measuring device’s indication at the 12 ° before TDC position. Legend 1. Water house 2. Wax CSD 3. Spacer 4. Lever Notice: As there is no 12 ° mark, set midway between the 11 ° and 13 marks. Standard value: 0.5 mm (0.0197 in) 4) Remove the pump rear plug, connect a dial gage and set the lift at 1 mm (0.039 in).
Special Tool Measuring device: 5-8840-0145-0 N6A0060E 43. Injection Timing Adjustment (4HF1-2 model only) If injection timing is out of the specified range, fol- low the following procedure for adjustment: 1) Loosen injection pump fixing nuts and bracket bolt. 2) Adjust the mounting angle of injection pump: 5) Set the crankshaft damper pulley TDC mark to the pointer or 45 ° before TDC. 6) Set the dial gage to the “0” position. N6A0058E If injection timing is too fast, bring the injec- tion pump closer to the engine. If injection timing is too slow, put the injec- tion pump more distant from the engine.