Isuzu — Isuzu N Series Training Manual

1) When any of the cylinder block, crankshaft, crankshaft bearing, connecting rod, connecting rod bearing, and piston is replaced with a new one, cylinder head gasket thickness should be determined newly. 2) When replacing the cylinder head gasket alone without replacing any of the parts mentioned in 1) above, the gasket to be used should be the same grade as the one used before. 3) Correct the cylinder head gasket thickness is important. Installing the wrong thickness gas- ket can result in greatly reduced engine perfor- mance. 4) There are three cylinder head gaskets avail- able. 59. Piston Head Projection Measurement Based on the Timax obtained, select a gasket of the appropriate grade.

Select a cylinder head gasket. Clean thoroughly the top faces of the piston head and the cylinder body. Use the dial gauge to measure the piston head pro- jection. Take measurements at two locations for each cylinder. N6A1628E 4HF1/4HF1-2/4HG1-T Cylinder Head Gasket Selection The measurement points of the piston head and the reference point of the cylinder body are shown in the illustration. Measurement points: Points G1 and G2 of the pis- ton head Reference point: Point R on the top face of the cyl- inder body N6A1396E N6A0353E Notice: Note that there are three types of a cylinder head gasket available as shown in the table following, according to the piston projection.

For each cylinder, calculate the average value (Ti) of the piston projection. Find the maximum value (Timax) of the average value (Ti) of each cylinder.