Isuzu — Isuzu N Series Training Manual

Legend 1. Fan center 2. Fan pulley 3. Seal unit 4. Roller bearing 5. Ball bearing 6. Impeller N6A0378E Important Operations 1. Axial Type Oil Seal As crankshaft front and rear oil seals are both axial type, attention must be paid to the following: when replacing, replace oil seal and slinger as a set. Be sure to use the special tool correctly since oil seal and slinger must be set accurately in their longitudinal direction. 2. Valve Cap As intake and exhaust valves have caps, take sufficient care not to let them fall into the gear case or oil return hole during disassembly or reassembly. 3.

Application of Liquid Gasket Oil pan, crankcase, oil cooler, retainer front, and water pump are not sealed with sheet gasket but with liquid gasket only. Prior to application, be sure to remove old hardened liquid gasket or oil from those surfaces to which new gasket will be applied. Further, if the old gasket can hardly be removed, mask such surfaces with gasket re- mover (Three Bond PANDO-391D; ISUZU Genuine Parts No. 1-8844-0542-0) or equivalent in accordance with the instructions manual. Liquid gasket should be applied evenly so that no breaks and omissions may be made. Further, were O-ring is used should not be exposed to liquid gasket. 4.

Plastic-Region Angular Bolt Tightening Method Clamping bolts of connecting rod and cylinder head (M14 only) are tightened by plastic region angular bolt tightening method. This method is applied with bolt threads and setting faces coated with molybdenum disulfide grease.