Isuzu — Isuzu N Series Training Manual

N6A0438E 2. Idle Gear B The face of the idle gear B with longer boss should be positioned toward the rear side shown in the il- lustration. N6A0437E Tighten: Idle gear B bolt to 110 N m (11.2 kg m/81 lb ft) If the clearance between the idler gear shaft outside di- ameter and the idler gear inside diameter exceeds the limit, the idler gear must be replaced. Installation 1. Idler Gear B Shaft Tighten: Idle gear B shaft bolt to 31 N m (3.2 kg m/23 lb ft) Apply the engine oil to the idle gear shaft after in- stallation. N6A0439E 3.

Idle Gear A 1) Turn the crankshaft clockwise so that the en- gagement mark of the crankshaft gear faces to the shaft center of the idle gear A and the No.1 cylinder piston comes to the top dead center. 2) Align the crankshaft gear with the engagement mark of the idle gear and install the idle gear A. Tighten: Idle gear A bolt to 133 N m (13.6 kg m/98 lb ft) Idler Gear Inside diameter mm (in) Standard Limit 30.000 — 30.021 (1.1811 — 1.1819) 30.100 (1.1850) Idler Gear Shaft and Idler Gear clearance mm (in) Standard Limit 0.020 — 0.062 (0.0008 — 0.0024) 0.200 (0.0079)