Isuzu — Isuzu N Series Training Manual

Above works refer to “ENGINE ASSEMBLY” sec- tion in this manual. 4. Clutch Pressure Plate Assembly 5. Driven Plate 6. Flywheel Assembly Above works refer to “FLYWHEEL AND PILOT BEARING” section in this manual. Legend 1. Oil seal 2. Slinger 3. Felt 8. Crankshaft Rear Slinger Use the slinger puller to pull out the slinger. Slinger Puller: 5-8840-2360-0 N6A6504E N6A0430E Legend 1. Washer 2. Pilot bearing Installation 1. Crankshaft Rear Slinger Press in the slinger using oil seal setting tool kit. 7. Crankshaft Rear Oil Seal Caution: Be careful not to damage the crankshaft oil seal contact surface during the removal procedure.

Insert the slinger (1) into the end of adapter (2) and install the adapter on the crankshaft. Cover the sleeve (3) and tighten the bolt until the sleeve comes to contact the adapter stop- per (4). N6A0618E N6A0429E