Make sure of the measurements specified in the illustration. (A): 7.8 ± 0.3 mm (0.307 ± 0.012 in) N6A6504E Legend 1. Washer 2. Pilot bearing N6A0623E Legend 1. Adapter 2. Adapter bolt 3. Center bolt 4. Oil seal 5. Ring 6. Collar 7. Sleeve 5) Remove the crankshaft stopper. 4. Driven Plate 5. Clutch Pressure Plate Assembly Above works refer to “FLYWHEEL AND PILOT BEARING” section in this manual. 6. Transmission Assembly Above works refer to “ENGINE ASSEMBLY” sec- tion in this manual. 7. Starter 3. Flywheel Assembly 1) Apply a coat of molybdenum disulfide grease to the flywheel bolt threads and setting faces.
2) Align the flywheel with the crankshaft knock pin and temporarily tighten the flywheel bolts. 3) Use the crankshaft stopper to prevent the crankshaft from turning. Crankshaft Stopper: 5-8840-2230-0 4) Install the washer and the flywheel bolts and tighten to the specified torque in numerical or- der show in the illustration. Tighten: Starter bolt to 76 N m (7.7 kg m/56 lb ft) Tighten: Flywheel bolt to 1st step: 78 N m (8.0 kg m/58 lb ft) 2nd step: 90 — 120 ° N6A0582E 8. Transmission Panel Connect the battery ground cable.