that the painted gear is at the center of the sensor mounting hole. Tighten: Injection pipe to 29 N m (3.0 kg m / 22 lb ft) Clip to 3 N m (0.3 kg m / 26 lb in) N6A0918E 7. Tighten injection pump clamping bolt and nut to specified torque: Tighten: Bolt to 48 N m (4.9 kg m / 35 lb ft) Nut to 24 N m (2.4 kg m / 17 lb ft) 8. With reference to Injection Timing Check & Adjust- ment, set No. 1 Cylinder to 12 ° before its TDC. Notice: In case the crank pulley has two marks as illustrated, (1) BTDC 49 ° mark on the second crest and TDC mark on the third crest (as viewed from the front side), be sure to set at the mark (2).
(If there are two different marks on one and same crest, set at the mark which comes sec- ond when rotated in the normal direction.) N6A1632E 10. Fuel Pipe Do not apply excessive force to the fuel pipe. Tighten: Fuel pipe joint bolt (1) to 41 N m (4.2 kg m / 30 lb ft) Fuel pipe joint bolt (2) to 23 N m (2.3 kg m / 17 lb ft) Clip screw to 4 N m (0.4 kg m / 35 lb in) N6A0055E 9. Injection Pipe (4HF1-2 model only) 1) Connect Injection Pipe and fix with clips as il- lustrated.