N6A0936E N6A0939E 5. Tighten the injection pump fixing nuts (1) to the specified torque. Legend 1. Lever 2. Spacer 3. Water hose 4. Wax CSD Tighten: Injection pump fixing nut to 25 N m (2.6 kg m / 19 lb ft) Notice: If there are two marks on the crank pulley, the front side of mark is for setting BTDC 49 ° and the rear side of mark is for setting TDC. 4. Remove the pump rear plug, connect a dial gage and set the lift at 1 mm (0.039 in). Special Tool Measuring device: 5-9940-0145-0 N6A0937E Injection Timing Check (4HF1-2 model only) N6A0940E 5. Set the crankshaft damper pulley TDC mark to the pointer or 45 ° before TDC. 1. Set No. 1 Cylinder to the TDC in the compression stroke. 2.
Disconnect Injection Pipe. 3. Put down Wax CSD lever, insert a spacer 10 — 12 mm (0.39 — 0.47 in) thick between the plunger and adjust bolt, and cancel the Wax CSD.