Isuzu — Isuzu N Series Training Manual

Pre-stroke adjustment Adjust No.1 cylinder’s start of static injection using the shim (1). Individual cylinder’s injection order adjustment Adjust difference between each cylinder’s injection an- gle based on that of the No.1 cylinder using the shim (1). N6A0962E Advice If measuring device (P/N 105782-6420) is removed, the output voltage (a1, a2) should be remeasured. Minimum advance angle adjustment stopper adjust- ment 1. Remove the screw (4) (P/N 157927-3321) and in- stall minimum advance angle adjustment stopper. 2. Screw in minimum advance angle adjustment stopper until No 1 cylinder’s pre-stroke is 3.84 — 3.90 mm (0.1512 — 0.1535 in). Then, tighten locknut to specified torque. 3.

Measure the output voltage (c) at this time. Solenoid switch adjustment 1. Apply 24 V voltage to solenoid switch (5). 2. Loosen solenoid switch (5) until No 1 cylinder’s pre-stroke is 1.90 — 2.03 mm (0.0748 — 0.0799 in), then tighten the locknut to the specified torque. 3. Confirm solenoid switch operates at 14.5 — 0.1 V. N6A0963E Measuring pre-stroke output voltage 1. Install the measuring device (P/N 105782-6420). 2. Remove the setscrew (3) (P/N 157927-2820) and install the air bleeder bolt. 3. Screw in screw (4) (P/N 157927-3321) and mea- sure the No 1 cylinder’s output voltage for pre- stroke lift values in the table below.

Adjusting point confirmation point Pre-stroke (mm (in)) Output voltage (actual) Remarks a 3.70 (0.1457) a1 + tolerance 3.44 (0.1354) a2 − tolerance b 3.24 (0.1276) b1 + tolerance 3.04 (0.1197) b2 − tolerance (calculate form each specification)