Isuzu — Isuzu N Series Training Manual

5. Adjust Nut Attach the end tip of the wire to the engine con- trol lever. Pull the outer cable gently toward the front of the vehicle, and provide the engine control wire and the accelerator control wire an appropriate play before fastening the clamp with a nut. Tighten: Nut to 8 N m (0.8 kg m /69 lb in) Check to see if the injection pump lever is at the idle position (with the lever in touch with the stopper bolt). Connect the battery ground cable. Check to see if the accelerator pedal fully is in the range of 5 — 10 mm (0.2 — 0.4 in) above the pedal pad.

Press down on the accelerator pedal fully, and check to see if the engine rotates at the maxi- mum speed with the linkage in the smooth op- eration. In the operating range of the accelerator pedal, check to see if the accelerator pedal and the in- jection pump lever return without fail to the orig- inal positions.