IDLING CONTROL CABLE Component N6A0976E Legend 1. Idling control knob 5. Screw 2. Idling control cable nut 6. Accelerator pedal bracket 3. Wave washer 7. Wire guide 4. Idling control cable Removal Insert the idling control cable into the specified hole of the instrument panel. 1. Idling Control Knob Loosen the idling control knob screw and re- move the knob from cable. 2. Idling Control Cable Nut 3. Wave Washer 4. Idling Control Cable Install the washer to the cable, and tighten it with a nut. 4. Idling Control Knob Insert the idling control knob into the cable, and tighten the screw. Inspection: Remove control cable from accelerator pedal bracket.
With the idling control knob not in use, check to see if the injection pump lever is at the idle position (with the lever in contact with the stopper bolt). Installation 1. Idling Control Cable With the idling control knob turned fully to the right, check to see if the number of the engine idling ro- tations gets to 1,500 rpm or more. Install control cable to Accelerator pedal brack- et. 2. Wave Washer 3. Idling Control Cable Nut