um Switching Valve) with a ECM controlled EVRV (Elec- tronic Vacuum Regulating Valve). The ECM monitors related sensor or switch condition, if EVRV solenoid has incorrect operation, DTC P31 or P32 will be set. If DTCs P13, P14, P21, P22,P35, P36, P45 or P61 are set, refer to the DTC charts. Rack Sensor The rack sensor is engaged with tip of injection pump rack. The rack sensor signal will send during vehicle operat- ing to the ECM, the ECM calculate together with other sensor’s signal, the ECM output activation signal for EVRV. Atmospheric Pressure Sensor The atmospheric pressure censor is built-in the ECM.
The EVRV activity will be stopped, when the atmospher- ic pressure will comes below the setting pressure. Exhaust Brake Switch The exhaust brake switch is equipped on the steering column. The exhaust brake switch is controlled by vehicle oper- ator, when during the vehicle operating the vehicle oper- ator will demand to apply the exhaust brake for assist the main brake system. EGR Quick Cut Control During the VSV action, when the EVRV drive current will comes over the setting valve (the drive current will de- cide relation of the engine load and speed) immediate stop the VSV. Result of this action will reduce the PM (Particulate Mat- er).
EVRV Control The EGR is controlled under normal temperature with separate stage by the ECT of engine condition. ECM refer to EGR action map to demand the EVRV drive current, also ECM controls agree EVRV drive cur- rent and EVRV actual drive current each other. Otherwise the ECM transitional stage controls for cur- rent of EVRV when EGR is controlled moving OFF area to ON area on the EGR action map. Also stop the EVRV drive for stop the EGR system un- der following conditions. When under low temperature of the ECT. When acting the QWS system. When acting the exhaust brake When the atmospheric pressure comes under setting the pressure valve.