Step Action Value YES NO 1 Was the “on-board diagnostic (OBD) system check” performed? — Go to Step 2 Go to self diag system check 2 Remove Sensor Connector. Has DTC22 been corrected? (Ignore DTC21) — Go to Step 3 Go to Step 7 3 1. Jump between Harness signal Terminal and GND terminal at the Sensor side of Connector. 2. Ignition “ON” Has DTC22 been corrected? — Go to Step 4 Go to Step 5 4 1. Check the Sensor Connector for inter ter- minal short. After check, repair if necessary. Was Connector Terminal shorted? — Go to Step 12 Go to Step 6 5 1. Check GND Circuit for disconnect. After check, repair if necessary. Is GND circuit disconnect? — Go to Step 12 Go to Step 11 6 1.
Check Sensor Harness signal circuit and power source circuit for short. After check, repair if necessary. Was Harness shorted? — Go to Step 12 Go to Step 8 7 1. Check Harness signal circuit and power source for short. After check, repair if necessary. Was Harness shorted? — Go to Step 12 Go to Step 11 8 1. Apply 5V to RACK+ TERMINAL. 2. Measure RACK SIG Voltage. Is RACK SIG VOLTAGE as specified? 0.9 — 2.0V (Idling speed) Go to Step 9 Go to Step 10 9 1. Check the iron core of RACK Sensor for damage, seizure, and wear. 2. After check, repair if necessary. Was there any trouble in the iron core(RACK end) inside RACK Sensor? — Go to Step 12 Go to Step 11 10 Replace the RACK Sensor.
Is the action complete? — Go to Step 12 — 11 Replace the ECM. Is the action complete? — Go to Step 12 — 12 1. Reconnect all the connectors removed. 2. Ignition “ON”, Engine “OFF” Is DTC22 all right under Scan Tool Check? — Go to Step 13 Go to Step 2 13 Is any current trouble other than DTC 22 dis- played by scan tool? — Go to trouble code section Trouble code clear