Resistance value Notice: Resistance value is difference according to the engine temperature (condition of engine warming up). Inspection Point Resistance Value (kΩ) Reference Connector Pin No. 2 pin Black 2 ←→ 1 12±1 (for 12 volt) 48±2 (for 24 volt) SIG ←→ GND 1 ←→ Body ∞ SIG ←→ Body Step Action Value YES NO 1 Was the “on-board diagnostic (OBD) system check” performed? — Go to Step 2 Go to self diag system check 2 1. Ignition “OFF” 2. Disconnect the EVRV from the wiring har- ness connector. 3. Check the EVRV signal circuit between the EVRV connector and the ECM for the following condition. • A short to ground • An open circuit 4. Repair if necessary. Has DTC31 been corrected?
— Go to Step 7 Go to Step 3 3 Using the DVM, check the resistance of the EVRV. Does the DVM read the following Value? 12Ω (for 12 Volt) 48Ω (for 24 Volt) Go to Step 4 Go to Step 5 4 1. Ignition “OFF” 2. Check an open circuit of the EVRV ground circuit between the ECM and EVRV connector. 3. Repair if necessary. Has DTC31 been corrected? — Go to Step 7 Go to Step 6 5 Replace the EVRV. Is the action complete? — Go to Step 7 Go to Step 6 6 Replace the ECM. Is the action complete? — Go to Step 7 — 7 1. Reconnect all the connectors removed. 2. Ignition “ON”, Engine “OFF” Is DTC31 all right under Scan Tool Check?
— Go to Step 8 Go to Step 2 8 Is any current trouble other than DTC31 dis- played by scan tool? — Go to trouble code section Trouble code clear