Isuzu — Isuzu N Series Training Manual

Step Action Value YES NO 1 Was the “on-board diagnostic (OBD) system check” performed? — Go to Step 2 Go to self diag system check 2 1. Ignition “OFF”, with scan tool disconnect- ed. 2. Disconnect the Relay solenoid switch from the Relay box. 3. Apply a circuit tester with the voltage range or a test light to the output circuit for the Relay. 4. Ignition “ON”, Engine “OFF”. Is voltage as prescribed, or is test Light lit until 18 seconds? ≥8V or light “ON” (for 12 Volt) ≥16V or light “ON” (for 24 Volt) Go to Step 3 Go to Step 4 3 1. Ignition “OFF” 2. Disconnect the ECM connector from ECM. 3. Check the short to voltage of Relay circuit between the ECM and Relay connector. 4.

Repair if necessary. Has DTC 42 been corrected? — Go to Step 6 Go to Step 5 4 Replace the VSV. Is the action complete? — Go to Step 6 — 5 Replace the ECM. Is the action complete? — Go to Step 6 — 6 1. Reconnect all the connectors removed. 2. Ignition “ON”, Engine “OFF” Is DTC 42 all right under Scan Tool Check? — Go to Step 7 Go to Step 2 7 Is any current trouble other than DTC 42 dis- played by scan tool? — Go to trouble code section Trouble code clear