Isuzu — Isuzu N Series Training Manual

Step Action Value YES NO 1 1. Ignition “ON”, Engine “OFF” 2. Connect a voltmeter to the ECM connec- tor terminals (ENGINE+) and (ENGINE-) Is the voltage 0V? — Go to Step 3 Go to Step 5 2 1. Ignition “ON”, Engine “ON” 2. Connect a voltmeter to the ECM connec- tor terminals (ENGINE+) and (ENGINE-). Is the voltage under the range of 0 — 1V (AC intermittently) when the engine speed is about 2000RPM? Does the Voltage increase as the engine speed is increased? — Go to Step 4 Go to Step 6 3 Check for poor sensor ground or sensor signal circuit terminal connection and terminal shorted at the ECM and replace terminal(s) if necessary. Did any of the terminals need to be replaced?

— Go to Step 8 Go to Step 4 4 1. Check sensor signal circuit for disconnec- tion and power source for short. 2. Check sensor GND circuit for disconnec- tion and power source for short. 3. Repair if necessary. Was repair needed? — Go to Step 8 Go to Step 5 5 1. Check signal circuit for GND short. 2. Repair if necessary. Was repair needed? — Go to Step 8 Go to Step 7 6 Replace the sensor. Is the action complete? — Go to Step 8 — 7 Replace the ECM. Is the action complete? — Go to Step 8 — 8 1. Reconnect all the connectors removed. 2. Ignition “ON”, Engine “OFF” 3. Connect the Scan Tool. 4. Ignition “ON” Engine “OFF” 5. Make Scan Tool indicate engine speed.

Is a speed range of 700 rpm to 900 rpm indi- cated with the engine idling (accel. off)? And as engine speed rises with accel. on, does the indicated value rise? — Go to Step 9 Go to Step 2 9 Is any current trouble other than DTC 45 dis- played by scan tool? — Go to trouble code section Trouble code clear